Zanussi ZMB 30 CST instruction manual Connecting to the mains, Important information

ZMB 30CST

t

Important information

Connecting to the mains

•The oven is delivered with the power cord and a plug for 230-240 V, 50Hz, earthed socket outlet.

•Earth protection minimizes the risks should a short-circuit occur. Check to ensure the voltage of the oven matches the supply. N.B. If the oven is connected to the socket via an extension cord, make sure the cord is earthed.

This appliance must not be used on a non-earth protected power supply. Contact an electrician if you are uncertain regarding electrical connection of the oven or provision of earth protection of the supply.

•Microwave power output : 900W

•This appliance complies with E.E.C. directive No. 87/308 of 2.6.87 relative to radio interference suppression.

Information concerning UK installation

•If this appliance is fitted with a non- rewirable plug for which your socket is un-suitable, the plug should be cut off and the appropriate plug fitted. If it is neces-sary to change the fuse in a nonrewi-rable plug, the fuse cover must be refit-ted. If the fuse cover is lost or damaged, the plug must not be used until a re-placement is obtained.

•The plug moulded on to the lead incorporates a fuse. For replacement, use a 13 Amp BS1362 fuse. Only ASTA or BSI approved fuses should be used.

•The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover / carrier is indicated by the coloured insert at the base of the plug and must be obtained from your local Electrolux Service Centre.

IMPORTANT

•The wires in the mains lead are coloured in accordance with the following code:

GREEN AND YELLOW EARTH

BLUENEUTRAL

BROWNLIVE

•If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug, proceed as follows:

Connect the green and yellow (earth) wire to the terminal in the plug which is

marked with the letter ‘E’ or the earth

symbol ( ) or coloured green and yellow.

Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter ‘N’ or coloured black.

Connect the brown (live) wire to the terminal in the plug which is marked with the letter ‘L’ or coloured red.

GREEN & YELLOW

13 AMP FUSE

BROWN

BLUE

CORD

CLAMP

7