Using the appliance
Starting the programme
1. Scrape or rinse off solid food remnants.
2.Load the dishwasher.
(See the basket and loading).
3.Put the correct amount of detergent into the detergent dispenser and close the lid.
4.Close the door.
5.Press in the On/Off button. All programme indicator lamps are lit.
6.Press in the required programme button (see pro- gramme chart). All other programme indicator lamps go out. The lamp always indicates which part of the selected cycle the dishwasher is in.
7.Check the filters to see if they need to be cleaned when the dishwasher has finished the programme.
Interrupting the programme temporarily
1. Open the door. The programme stops.
2.The programme indicator lamp is lit.
3.Close the door and the programme continues after about six seconds.
Open the door carefully when the dishwasher is running, since hot steam may escape.
Cancelling the programme
1. Press and hold in the combination buttons, the machine goes to starting position and all pro- gramme indicator lamps are lit.
2.Release the buttons. The programme is now cancelled and a new programme can be selected.
If you switch the dishwasher off with the On/Off button, the selected programme is not finished, it is only disrupted. When you start the dishwasher again, the programme will continue.
Pause function
With the pause function the programme can be temporarily interrupted for a short period of time.
1. Press in the On/Off button. The programme stops.
2.All lamps goes out.
3.When you want the programme to continue again, you press the On/Off button. The programme continues.
The programme should not be paused for any longer then necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is completed, you can cancel it.
1. Press in the On/Off button.
2. Open the door. The drying phase is cancelled.
Switching the dishwasher off
Switch the dishwasher off, when the indicator lamp 
for the programme cycle end is lit or the display shows 0.
1. Press in the On/Off button.
Leave the door slightly ajar.
Be careful if you open the door immediately after the programme is finished, since hot steam may escape.
This dishwasher is equipped with the new flush system called ”IMPULSE WASHING”. This washing system varies both the revolutions of the pump and the water pressure for more inten- sive cleaning of the dishes during a programme. That is why different sections of the programme cycle do not sound the same.
- 10 -
