HDMI-UTPRO-RX NetLinx Programming
Overview
The
NetLinx programming is supported only if the
The main Device SEND_COMMANDs are described on page 92. IR SEND_COMMANDs are described on page 93.
SERIAL SEND_COMMANDs are described on page 96.
Device Numbering
In NetLinx Studio’s Online Tree, the HDMI UTPro is listed as a device with a single port, and each
Note: Only RX units that are physically connected to the HDMI UTPro will be represented in the Online Tree.
The device number for each
Therefore, it important to avoid assigning device numbers that will conflict with this
In NetLinx Studio’s Online Tree, each
Ports
Ports
Port 1 - main device port Port 2 - Serial
Ports
FIG. 61 NetLinx Studio Online Tree - Ports 1-3 on first three connected HDMI-UTPRO-RX Receivers
The three ports relate directly to the three types of NetLinx commands recognized by the
Port 2 - SERIAL (RS232) SEND_COMMANDs Port 3 - IR SEND_COMMANDs
Note: For additional information on using NetLinx Studio, refer to the “Programming Guide – NetLinx Integrated Controllers” (available at www.amx.com).
Instruction Manual – | 91 |
|
|
