AMX HDMI-UTPRO-0808 instruction manual Admin Menu, Control Page, Control Commands

HDMI UTPro WebConsole

Admin Menu

Several configuration pages are included in the Configuration Manager, all of which are accessed via the Admin drop-down menu (FIG. 44).

FIG. 44 Configuration Manager - Admin drop down menu

Click on an option in this menu to access each of the configuration pages, as described in the following sections. The Restore Settings menu option restores the factory default settings on both the Security Settings page and the Port Settings page.

Control Page

Select Control from the Admin menu to access the HDMI-UTPRO-0808 Control page (FIG. 45). Use this page to send NetLinx programming control commands to the HDMI UTPro Matrix Switcher or the HDMI-UTPRO-RX Receivers (Receivers must be connected). This page provides a rudimentary control method if a master connection is not available.

HDMI UTPro

Port 1 - control and switching Port 2 - output control strings to a

connected device Port 3 - reserved for future use

HDMI-UTPRO-RX

Port 1 - main device port / IR Receiver

Port 2 - Serial (RS-232) port

Port 3 - IR device port

FIG. 45 Configuration Manager - HDMI-UTPRO-0808 Control page

Control Commands

Note: Only ASCII-printable characters are supported.

To send commands to the HDMI UTPro:

1.From the Device drop-down menu, select Hub (for the HDMI UTPro).

2.From the Port drop down menu, select the applicable port for the command (FIG. 45). Port 1: SEND_COMMANDs

Port 2: SEND_COMMANDs to output control strings to a connected device

Port 3: reserved for future use

3.Enter the SEND_COMMAND in the Commands field on the left.

Instruction Manual – HDMI-UTPRO-0808 71