AMX HDMI-UTPRO-0808 instruction manual Hdmi UTPro Serial SENDCOMMANDs

GET BAUD command

SET BAUD

HDMI UTPro NetLinx Programming

SERIAL SEND_COMMANDs

SERIAL (RS-232) SEND_COMMANDs are sent to Port 2 on the HDMI UTPro.

HDMI UTPro SERIAL SEND_COMMANDs

GET BAUD	The port sends the parameters to the device that requested the information.
Get the RX serial port's	Syntax:
current communication	SEND_COMMAND <DEV>,"'GET BAUD'"
parameters.	Example:
	SEND_COMMAND dvUTProRS232,"'GET BAUD'"
	The port responds with:
	<port #>,<baud>,<parity>,<data>,<stop>
	Example:
	PORT 2,38400,N,8,1
SET BAUD	Syntax:
Set the serial	SEND_COMMAND <DEV>,"'SET BAUD <baud>,<parity>,<data>,<stop>'"
communication parameters.*	Variables:
	• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200 (default
	9600).
	• parity = N (none), O (odd), E (even)
	• data = 8 data bits
	• stop = 1 and 2 stop bits
	Example:
	SEND_COMMAND dvUTPro RS232,"'SET BAUD 19200,N,8,1'"
	Temporarily sets the HDMI UTPro serial port's communication parameters to 19200
	baud, no parity, 8 data bits, 1 stop bit.
TSET BAUD	Syntax:
Set the serial	SEND_COMMAND <DEV>,"'TSET BAUD <baud>,<parity>,<data>,<stop>'"
communication parameters.*	Variables:
	• baud = baud rates are: 115200, 57600, 38400, 19200, 9600, 4800, 2400, 1200 (default
	9600).
	• parity = N (none), O (odd), E (even)
	• data = 8 data bits
	• stop = 1 and 2 stop bits
	Example:
	SEND_COMMAND dvUTPro RS232,"'TSET BAUD 19200,N,8,1'"
	Temporarily sets the HDMI UTPro serial port's communication parameters to 19200
	baud, no parity, 8 data bits, 1 stop bit.

*Both commands for setting the baud rate are accepted by the HDMI UTPro and work the same way. When the system is rebooted or power cycled, the serial ports default to 9600, N, 8, 1.

Instruction Manual – HDMI-UTPRO-0808 87