
Installation and Setup
2.
3.Click the plus symbol (+) to the left of the “AMX
To test the HDMI UTPro WebConsole connection:
1.Launch a browser on your PC.
2.In the address bar of the browser, type the IP address and press Enter (to determine the IP address, see the previous instructions or contact your Network Administrator).
If the WebConsole does not open, see the “WebConsole Troubleshooting” section on page 80.
For WebConsole setup details, see the “HDMI UTPro WebConsole” chapter on page 69.
Note: For additional information on
Serial Port (RJ-12)
The Serial port displays in NetLinx Studio as Port 2 of the HDMI UTPro and can be used to control an additional local device. The port is an
Important: This port cannot be used to control the
Note: Attaching an additional external device is an optional procedure in the installation process.
FIG. 21 Device control flow diagram
Instruction Manual – | 36 |
|
|