AMX HDMI-UTPRO-0808 instruction manual To attach cables for switching/transport, Hdmi-Utpro-Rx

Installation and Setup

Important: Before attaching source and destination devices, we recommend reading the “Setting Up HDMI Systems” chapter for information on concerns and considerations you should be aware of when switching HDMI (see page 60).

HDMI matrix switching input HDMI matrix switching output

Source device

HDMI cable

UTP cable up to 100 m (328 ft.)

HDMI-UTPRO-RX

HDMI cable

HDMI patch cable HDMI transport input

UTP (RJ-45) transport output

Destination device

FIG. 14 Cables connected for switching/transport from the first source to the first destination device

Important: UTP cable quality required in order to meet 100 meter distance should meet ANSI/TIA/EIA 568A-5 or better specification and be rated for 250 MHz or better.

To attach cables for switching/transport:

1.Attach an HDMI cable from the first source device to the first HDMI matrix switching input connector.

2.Attach one end of an HDMI patch cable (provided) to the first HDMI output connector.

3.Attach the other end of the HDMI patch cable to the first HDMI transport input connector.

4.Repeat Steps 1 through 3 for the remaining source devices; be sure each patch cable is connected to corresponding numbers (2 to 2, 3 to 3, etc.). The number for the HDMI matrix switching output connector and number for the HDMI transport input connector must match for each patch cable.

5.Attach a UTP cable to the first UTP (RJ-45) transport output connector.

6.Attach the other end of the UTP cables to the RJ-45 input connector on the first HDMI-UTPRO-RX Receiver. For mounting information for the Receivers, see page 15.

7.Repeat Steps 5 and 6 for the remaining Receivers.

8.Connect the HDMI-UTPRO-RX Receivers to the destination devices using HDMI cables.

Instruction Manual – HDMI-UTPRO-0808 31