AMX HDMI-UTPRO-0808 Serial Port Default Communication Settings, Cable Adapter Kit FG-RS01K

Installation and Setup

Serial Port - Default Communication Settings

The default serial settings for the Serial port are listed in the table below. The settings can be altered by sending SEND_COMMANDs to Port 2 of the HDMI UTPro (see page 87) or the Receiver (see page 92).

Serial port (RJ-12) connector

FIG. 22 Serial (RJ-12) port on the HDMI UTPro

Default Serial Port Settings

Baud Rate	9600
Data Bits	8
Parity	None
Stop Bits	1
Flow Control	None

Cable Adapter Kit (FG-RS01K)

A cable adapter kit is available that contains an RS-232 serial transmit, straight-through, adapter cable and two adapters. The kit allows you to use the adapter cable in one of three ways depending on your needs.

Serial port as DTE (data terminal equipment) interface with male connection:

Note: This cable configuration provides the equivalent of a serial port connection to a NetLinx Master.

Null Modem

Male-Female

Adapter

Male-Male

Adapter

DB-9 Serial Port Pinouts

(male connector)

RS-232

Pin 2: RX signal

Pin 3: TX signal

Pin 5: GND

FIG. 23 DTE interface with male connection

Serial port as DTE interface with female connection:

Null Modem

Male-Female

Adapter

DB-9 Serial Port Pinouts

(female connector)

RS-232

Pin 2: RX signal

Pin 3: TX signal

Pin 5: GND

Female

FIG. 24 DTE interface with female connection

Serial port as DCE (data circuit-terminating equipment) interface with male connection:

Male-Male

Adapter

DB-9 Serial Port Pinouts

(male connector)

RS-232

Pin 2: TX signal

Pin 3: RX signal

Pin 5: GND

FIG. 25 DCE interface with male connection

Instruction Manual – HDMI-UTPRO-0808 37