AMX HDMI-UTPRO-0808 RS-01 Adapter Cable FG-RS01, Serial Port RJ-12 Pinout, RX RJ-12 Pinout

Installation and Setup

RS-01 Adapter Cable (FG-RS01)

The adapter cable can be ordered by itself for a DCE interface with female connection. Serial port as DCE interface with female connection:

Female

FIG. 26 DCE interface with female connection

DB-9 Serial Port Pinouts

(female connector)

RS-232

Pin 2: TX signal

Pin 3: RX signal

Pin 5: GND

Serial Port (RJ-12) Pinout

The following table provides the pinout configuration for the RJ-12 connector (Serial port) on the HDMI-UTPRO-0808 and also on the HDMI-UTPRO-RX Receiver.

RX RJ-12 Pinout
Function	Abbreviation	RJ-12 Connector
Data Set Ready	DSR	Pin 1
Transmit Data	TD or TX or TXD	Pin 2
Receive Data	RD or RX or RXD	Pin 3
Signal Ground	GND	Pin 4
Signal Ground	GND	Pin 5
Data Terminal Ready	DTR	Pin 6

To connect an external serial device:

1.Plug the RJ-12 end of the adapter cable into the Serial port on the HDMI UTPro (or Receiver).

2.As needed – Connect cable adapter(s) per the desired Cable Kit option on the previous page.

3.Plug the DB-9 end of the adapter cable (or the end cable adapter) into the serial port on the external device.

HDMI UTPro

RJ-12 Port Settings

Baud Rate	9600
Data Bits	8
Parity	None
Stop Bits	1
Flow Control	None

4.Check to be sure that the device’s serial port settings and serial port settings on the enclosure (see table to the right) correspond to each other. If necessary, the default settings on the HDMI UTPro can be changed; see page 87.

Caution: To avoid system damage, follow the power-up sequence on page 40.

Instruction Manual – HDMI-UTPRO-0808 38