AMX HDMI-UTPRO-0808 instruction manual HDMI UTPro = device number

HDMI UTPro NetLinx Programming

Note: Only HDMI-UTPRO-RX units that are physically connected to the HDMI UTPro will be represented in the Online Tree.

The device number for each HDMI-UTPRO-RX Receiver currently connected to the HDMI UTPro is automatically designated a device number, based on the device number of the HDMI UTPro to which it is connected and to the number of the HDMI UTPro Output UTP (RJ-45) port (1-8) on the HDMI UTPro to which it is physically connected.

For example, if the HDMI UTPro is using its default device number assignment of 05500, and eight HDMI-UTPRO-RX Receivers are connected to all eight UTP Output ports on the HDMI UTPro, then the device numbering would be assigned as follows:

HDMI UTPro = device number 05500

HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port HDMI-UTPRO-RX connected to UTP Output Port

#1 = device number 05501 #2 = device number 05502 #3 = device number 05503 #4 = device number 05504 #5 = device number 05505 #6 = device number 05506 #7 = device number 05507 #8 = device number 05508

Therefore, it is important to avoid assigning device numbers that will conflict with this auto-numbering scheme. Reserve the eight device numbers following the HDMI UTPro’s device number assignment for up to eight HDMI-UTPRO-RX Receivers.

Note: The HDMI-UTPRO-RX Receivers that are connected to the HDMI UTPro UTP output ports on the HDMI UTPro are not required to be in sequential order. For example, if you had three HDMI-UTPRO-RX units, plugged into UTP Outputs 2, 5 and 7, the device numbers (assuming the default device number of the HDMI UTPro = 05500) would be 05502, 05505 and 05507.

In the device tree, each HDMI-UTPRO-RX Receiver displays three ports (FIG. 57)

Ports 1-3 on HDMI-UTPRO-RX	Port 1 - main device port / IR Receiver
	Port 2	- Serial (RS-232) port
(device number 05501)
	Port 3	- IR device port

FIG. 57 NetLinx Studio Online Tree - Ports 1-3 on each connected HDMI-UTPRO-RX

These three ports relate directly to the three types of NetLinx commands recognized by the HDMI-UTPRO-RX: Port 1 – SEND_COMMANDs

Port 2 – SERIAL (RS-232) SEND_COMMANDs Port 3 – IR SEND_COMMANDs

For instructions on programming the HDMI-UTPRO-RX, refer to the “HDMI-UTPRO-RX NetLinx Programming” chapter on page 91.

Note: For additional information on using NetLinx Studio, refer to the “Programming Guide – NetLinx Integrated Controllers” (available at www.amx.com).

Instruction Manual – HDMI-UTPRO-0808 84