Tips & tricks, settings
36
appendix.fm5
16.4.99 Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1
Hardware problems (PC, modem, ISDN TA.):
The modem parameter request
function is not working or is not
correct.
For example, under Win 95 with
<Start><Settings><Control
Panel><Modem Proper-
ties><Diagnostics><Details>
Windows is not respecting the
AT Hayes conditions. None
Technically specified time de-
lays that are not supported by
the modem’s driver software.
None
Data transmission with
Xmodem is very slow.Xmodem is operating in half-du-
plex mode. After every data
package, the transmitting page
waits for acknowledgement.
The 20-30 ms signal delay per
data block on the DECT inter-
face significantly reduces the
transmission speed.
Use another transmission proto-
col, e.g. Zmodem.
Laplink 7.0 is not working. Data transmission is switched
during transmission. AT Hayes
commands are not used for
this.
None
Fault Cause Solution
Fault Cause Solution
PABX (telecommunications
system) cannot be configured
via a Gigaset M101 Data.
PABX configuration is not com-
patible with AT Hayes . Configure Gigaset M101 Data in
direct mode (e.g with
9600,8,N,1).
In the case of the system, the
baud rate is switched with an in-
ternal command set that is not
compatible with AT Hayes.
None
ELSA TagGo2000 / ISDN con-
figuration not possible. ---------------------------- Configure the modem with a di-
rectly connected serial cable.
The ELSA TanGo 2000 terminal
adapter cannot be used under
AOL.
No appropriate modem profile
is available. Tests have shown that an oper-
ative X.75 connection is set up
with the modem profile "ISDN
ELSA TLV34 X.75 64,000".
Timers such as "Heliowatt" can-
not be programmed. Incorrect protocol set. Set Gigaset M101 Data to 300
bps direct connection. Data
flow setting: without.
The ACER ISDN T30 terminal
adapter cannot be operated un-
der AOL with the initialisation
string specified in the manual.
The initialisation string is incor-
rect. The character "/" must be re-
placed by a "~".
The Hagenuk Speed Dragon
terminal adapter cannot be
used with the software RVS-
COM.
Commands that are not com-
patible with Hayes are trans-
ferred with the connection.
Set the Gigaset M101 Data to
115,000 bps direct connection,
see "PC-PCdirect cable con-
nection: via RS232/V.24 inter-
face" on page 25