Siemens M101, RS232 LEDs and buttons

gigam101.fm5

21.4.99 Gigaset V.24 Adapter dt/eng:A30853-X400-B104-3-74D1

LEDs and buttons

There are two LEDs and a black button on the front of the Gigas-

et M101 Data unit.

Setting a Basis to logon mode

Press the button on a powered base-type device for 10 seconds.

The two LEDs blink in sequence, thus indicating that the device

is in logon mode. Logon mode is automatically deactivated after

successful logon or after 10 minutes: the blinking stops.

Resetting the device to the factory default

Press and hold down the button on the device that has been dis-

connected from the mains. Connect the device to the power

supply while holding the button down. LED 2 lights up after 10

seconds. This LED goes out in another 10 seconds indicating

that the reset operation has been successful. The button can

then be released.

LED 1 indicates stand-by mode:

LED 2 indicates the status of the transmission route on the

V.24/RS232 interface:

LED 1 blinks The station is searching for the part-

ner or has not been registered.

LED 1 is constantly il-

luminated The partner was found, the transmis-

sion route is on stand-by.

LED 2 off No data transfer

LED 2 flickers Data transfer active