What to do if …
Resetting the language
You can reset the language of the display to the fac- tory setting at any time.
1.Press the Cancel button repeatedly until what is shown in the display no longer changes.
2.Press and hold the Cancel button for six seconds.
LANGUAGE ENGLISH appears in the text line. The word ENGLISH flashes.
3.Using the Options button, select the desired lan- guage.
4.Press the Ok/Start button.
Remedying small malfunc- tions
If one of the following fault messages is displayed in the display during operation:
–OPEN THE TAP
–DRAIN BLOCKED
Remedy the fault, then
In the case of other fault messages:
–Cancel the dishwashing cycle.
–Switch the appliance off and on again.
–Select dishwashing cycle.
–Press the Ok/Start button.
If the fault is displayed again, please contact the Service Force Centre and inform them of the fault message.
Malfunction | Possible cause | Remedy | |
|
|
| |
| Tap is blocked with limescale or is | Check the tap and have it repaired, if | |
| faulty. | necessary. | |
|
|
| |
| The tap is turned off. | Turn on the tap. | |
|
|
| |
| The filter (where present) in the | Clean the filter in the threaded hose | |
| threaded hose fitting on the tap is | ||
| fitting. | ||
1 short warning tone, continu- | blocked. | ||
| |||
ously repeated, can be heard, |
|
| |
| Cancel the dishwashing cycle (see | ||
in the display: OPEN THE TAP |
| ||
Filters in the base of the washing | chapter: Starting a dishwashing cy- | ||
| |||
| cle); | ||
| compartment are blocked. | ||
| clean filters (see chapter: Cleaning | ||
|
| ||
|
| the filters). | |
|
|
| |
| Water inlet hose has not been cor- | Check the position of the hose. | |
| rectly positioned. | ||
|
| ||
|
|
|
30
