Changing the light bulb

Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows:

unscrew the light cover and then pull it outward by pressing as shown in the figure.

Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Service Force Centre).

Replace the light cover by sliding it into its original position and replacing the screw.

D411

When the appliance is not in use

When the appliance is not in use for long periods, dis- connect from the electricity supply, empty all foods and clean the appliance, leaving the door ajar to pre- vent unpleasant smells.

SOMETHING NOT WORKING?

Before contacting your local Service Force Centre check the following points.

IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.

Symptom

Solution

 

 

No power to appliance

- Check there is power at the socket.

 

- Check there is not a power cut by checking the

 

household lights.

 

- Check the fuse has not blown.

The light does not come on

- Ensure that the bulb is correctly fitted.

 

- Replace the bulb if it has blown.

 

- Check the door light switch is not jammed.

The temperature in the appliance is too high

- Check the ambient temperature is within the appliances

 

operating limits of 10˚C to 32˚C.

 

- Check the thermostat control knob is turned to the

 

correct setting relative to ambient conditions.

The compressor runs continuosly

- Adjust the thermostat control knob to give correct

 

temperature control. See page 4.

 

- Check that the door is closed.

 

- Large quantities of food have recently been placed in

 

the cabinet and/or door is frequently opened.

 

- Check that air ventilation is not obstructed.

Excessive frost and ice has built up

- Ensure the door is not left open.

 

- Check that nothing is preventing the door from closing.

 

- Is the door gasket intact and clean?

Noise

- Refer to normal operating sounds.

Water under the salad bin

- Check the drain hole is not blocked. (see Maintenance

 

and Cleaning).

 

 

If after the above checks, there is still a fault, call your local Service Force Centre. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

Please note that proof of purchase is required for any in-guarantee service calls.

8

Page 8
Image 8
Zanussi ZU 9155 manual Something not WORKING?, Changing the light bulb, When the appliance is not in use