Zanussi ZU 9155 manual Technical Specifications, Installation, Positioning

Models: ZU 9155

1 16
Download 16 pages 45.1 Kb
Page 11
Image 11
TECHNICAL SPECIFICATIONS

TECHNICAL SPECIFICATIONS

DIMENSIONS

Height

81,5

cm

 

Width

56

cm

 

Depth

53,8

cm

POWER SUPPLY VOLTAGE AND FREQUENCY

220-240 V / 50 Hz

 

TOTAL POWER ABSORBED

70 W

 

 

AVERAGE DAILY UNITS ELECTRICITY (*)

0,50 kWh

 

 

GROSS CAPACITY

138 l

 

 

NET CAPACITY

135 l

 

 

(*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located.

INSTALLATION

Warning

IF YOU ARE DISCARDING AN OLD APPLIAN- CE THAT HAS A LOCK OR CATCH ON THE DOOR, YOU MUST ENSURE THAT IT IS MADE UNUSABLE TO PREVENT YOUNG CHILDREN BEING TRAPPED INSIDE.

Depending upon the position which you choose for your appliance, you may wish to reverse the way in which the door opens. To do this, refer to instructions under “Door reversal”.

Positioning

The appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located on the inside left of the appliance. The following table shows which ambient tempera- ture is correct for each climate classification.

SN

+10°C

to

+32°C

ST

+18°C

to

+38°C

Important

It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation.

The appliance should be located in a dry atmos- phere, out of direct sunlight and away from continu- ous heat and extreme temperature, e.g. not next to a boiler or radiator or in a very cold room e.g. an out- house. If these temperatures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.

For building-in and door reversal instructions please refer to the relevant instructions on the following pages.

11

Page 11
Image 11
Zanussi ZU 9155 manual Technical Specifications, Installation, Positioning