Building In
These hobs can be inserted in a
The edge of the cut out must have a minimum distance from the rear wall of 55 mm.
If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 100 mm.
Hanging furniture units or hoods must be placed at 650 mm. minimum from the hob.
A= Auxiliary burner SR = Semirapid burner PE = Electric hotplate
Fitting the hob to the worktop
The hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in fig.
9. To install the hob, proceed as follows:
1)Remove the pan supports, the burners caps and crowns and turn the hob upside down, taking care the ignition candles are not damaged in this operation.
2)Place the sealing gasket (supplied with the hob) on the edges of the cut out, taking care that the sealings meet without overlapping;
3)Fix the hob with the relevant fixing clamps, supplied with the accessories bag (fig. 10). The traction of the screws is able to trace the sealing, any excess of which can be easily removed.
The edge of the hob forms a double labyrinth seal which provides a total guarantee against infiltration of liquids.
WARNING: When securing the fixing clamp near the terminal block, always ensure the connection cable does not come in contact with the edge of the clamp (see fig. 11).
PE
PE | SR |
A
580 | 500 |
Dimensions are given in millimeters
Fig.9 FO 2098 |
FO 0199
a
Fig.10
a) Sealing gasket
YES | NO |
A | A |
B | B |
Fig.11 |
|
A)Fixing clamp
B)Connection cable
11