Zanussi ZXS 646 IT manual Electrical Connection, Replacement of the voltage cable

Electrical Connection

The following instructions about installation
	YES	RIGID	COPPER PIPE OR
must be carried out by qualified personnel in
		FLEXIBLE		PIPE	IN STAINLESS
compliance with the regulation in force.		STEEL

The appliance is designed to be connected to 230 V monophase electricity supply.

The connection must be carried out in compliance with the laws and regulations in force.

Before the appliance is connected:

1) check that the main fuse and the domestic installation can support the load (see the rating label);

2) check that the power supply is properly earthed in compliance with the current rules;

3) check the socket or the double pole switch used for the electrical connection can be easily reached with the appliance built in the furniture unit.

The appliance is supplied with a connection cable. This
has to be provided with a proper plug, able to support the
load marked on the identification plate. To connect the
plug to the cable, follow the recommendation given in Fig.
5. The plug has to be fitted in a proper socket.
If connecting the appliance directly to the electric system,
it is necessary that you install a double pole switch
between the appliance and the electricity supply, with a
minimum gap of 3 mm. between the switch contacts and
of a type suitable for the required load in compliance with
the current rules.
Theconnectioncablehastobeplacedinorderthat,ineach
part, it cannot reach a temperature higher than 90 °C.
The brown coloured phase cable (fitted in the terminal
block contact marked with "L") must always be connected
to the network phase.	FO 0238	Fig. 5

Replacement of the voltage cable

Only cable types H05V2V2-F T90 or H05 BB-F (section: 3 x 1,5 mm2) must be used.

The yellow/green earth wire must be approximately 2 cm. longer than the phase wires (Fig. 6).

Neutral

Earth (yellow/green)

FO 0073

Fig. 6

9