BAR-ONE Installation
The A300 printer uses BAR-ONE software or ZPL II Programming Language sent from any Windows™ or DOS application.
1.Start Windows.
2.Insert disk 1 of the BAR-ONE software in your floppy disk drive (A: or
B:).
3.In Program Manager, click on the File menu. Select Run. (Windows 95 users: select Run from the Start menu.)
4.Type A:\SETUP (or B:\SETUP) and then press OK.
5.Follow the on-screen instructions to complete the installation.
Operating the System
To create a label for the A300, you may either use the BAR-ONE software to create the label format or write one in ZPL II , which is Zebra’s programming language for creating labels. If you are using BAR-ONE software, refer to the on-line BAR-ONE instructions. If you are using, or plan to use, the ZPL II programming language to format your labels, make sure you have a copy of the ZPL II Programming Guide. Refer to the mail-in/fax-in card included with the A300 printer to obtain a copy, if desired.
Printer Operating Modes
Tear-Off Mode. The operator tears off each label (or a strip of labels) as it is printed.
Peel-Off Mode. The backing material is peeled away from the label as it is printed, the printer waits until the operator removes the label, then the next label prints.