Zebra )300 User’s Guide
Printer Indicator Lights.
Table 2: Printer Indicator Lights
| Power | Fault Light | |||
| Light |
|
|
| |
Printer Condition |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Power is off or printer not receiving power |
| • |
|
| • |
Power is on | • |
|
|
| • |
Paper out or not sensed or | • |
|
| • |
|
Printhead is open |
|
|
| ||
|
|
|
|
| |
Printhead is over temperature | • |
| • |
|
|
Initial Printer Power-Up
Turn the printer on by pressing the Power Switch on the right side of the printer. The Power and Fault lights will turn on. The printer performs a set of internal diagnostics, and after the diagnostics have been completed (within
1 - 10 seconds) the Fault light will turn off. If you are using
If loading the printer with media for the first time, or changing the type of media, perform the Calibration below.
Calibration
This calibration procedure should be performed the first time you use the printer and any time you change the type of media in the printer.
1.Remove several labels from a section of backing material so that only the backing material is under the printhead mechanism.
2.Turn the printer power on if it is not already on.
3.Press and hold the Feed Key until the Fault light flashes twice in a row. (First it will flash once, then twice in a row at which point you release the key.)
4.The printer will adjust the media sensor level for the media backing you are using. After it is done making this adjustment, the Fault light will flash rapidly.
5.Reload the media so that a label is under the printhead.
#