Connect the Printer
•Plug the output cable from the Charger to the battery connection on the printer. (Re- fer to the QL 420 User’s Manual for more information.) If you are using a MMQ4 Mobile mount, it may be easier to plug in the charger connector before mounting the Printer to the Mobile Mount bracket.
•Turn the power source for the charger on, and verify that the indicator lights on the Charger’s front panel are lit and the Charger is functioning properly. Refer to Table 1 in the RCLI Mobile Charger Installation Guide for indicator display information.
CONNECTING A TERMINAL
If you are also installing a terminal in the vehicle, you normally must run two separate cables from the vehicle power source: one to the printer and one to the terminal. The terminal power cable must be either supplied by the terminal manufacturer or fabricated by the installer.
It is the installer’s responsibility to determine the suitability of running a terminal from the vehicle’s battery.
NOTE: Zebra Technologies Corporation is not liable for personal injury or damage to equipment caused by improper installation to any power source.
SPARE PARTS
The following list of parts is included with the MMQ4 Mobile Mount Kit. They are intended for use in the installation of the QL 420 printer and routing power and data I/O cables.
PART | DESCRIPTION |
|
| QTY. |
|
|
|
| |
SCREW, 1/ | ” HEX HD. | 5 | ||
| 4 | 2 |
|
|
30466 | WASHER .62 O.D. |
|
| 4 |
THRMP22CC370187 | CLAMP, CABLE |
|
| 2 |
SCREW | 2 | |||
SCREW, | 4 | |||
WASHER, LOCK # 8 | 4 | |||
WASHER, FLAT # 8 | 4 | |||
SPACER, | 1 | |||
52520 | BIN |
|
| 1 |
505203 | BRACKET MNTD LIFT TRUCK | 1 | ||
|
|
|
|
|
Mounting hardware for the Mobile Mount is not supplied in the kit.
Recommended fasteners for the Mobile Mount are 1/4” (6 mm) diameter hex head or socket head bolts with flat washers, lock washers, nuts and/or locking nuts.
Recommended fasteners for the Mobile Charger are
pg. 11 of 12 |