PRINTER INSTALLATION

Printer Preparation

Prepare the printer for installation by doing the following:

•If your printer has a carrying strap, you must remove it by the following procedure (Refer to Figure 4) :

1.Unscrew the (2) #4-40 x 1” screws holding the top corners of the printer together.

2.Remove the Carrying Strap and the (2) Bushings.

3.Replace the Bushings back in the top corners of the printer and re-install the two #4-40 x 1” screws

•Remove the Belt Clip from the back of the Printer (Refer to Figure 4).

•If your printer is equipped with a shoulder strap, remove it by un-clipping each end from the “D” rings.

•Always install the Battery prior to mounting the printer in the Mobile Mount.

Remove Carrying strap.

Replace bushings and screws after removing carrying strap.

Remove Carrying Strap by unscrewing corner screws

Remove Belt Clip by removing (2) screws.

Figure 4:

Printer Preparation

pg. 8 of 12

AM16629-1 Rev. C