Tools Required
•An electrical drill, drill bits 1/4”(6 mm))
•
•Common hand tools.
Reference
•QL 420 User’s Guide
•The
Contents of the Package
•The Mobile Mount Bracket Assembly
•The Lift Truck Mounting Bracket
•The Fanfold Bin
•A plastic bag containing mounting hardware, and the Fanfold Spacer
•This Guide
INTRODUCTION TO INSTALLATION
The MMQ4 Mobile Mount allows you to mount a QL 420 printer into virtually any vehicle. The RCLI Mobile Charger (supplied separately from this kit) can provide a source of power to run and charge the printer’s battery from the vehicle’s electrical system.
Installation of the Mobile Charger is covered in the
In all installations, the power cable is wired to the vehicle’s battery power system indirectly through a power
CAUTION: Under no circumstances should the equipment be attached directly to the vehicle’s battery or an AC power sourcewithout a proper fuse.
Since each situation or equipment type may pose unique requirements, mounting hardware selection and mechanical installation shall be the responsibility of the installer. Zebra recommends using
NOTE: Hardware used to secure the Mobile Mount to the vehicle is not supplied in the kit. Recommended fasteners are 1/4” (6 mm) diameter hex head or socket head bolts with flat washers, lock washers, nuts and/or locking nuts.
Your tasks are to:
•Mechanically install the MMQ4 Mobile Mount
•Install the Mobile Charger (if used in this installation) according to the
•Connect the Data I/O cable from the data terminal (if used) and the output cable from the Mobile charger.
Decide where you will mount the printer, then proceed with the following instructions.
Installing a Terminal
You most likely will be installing a terminal at the same time. Follow the terminal manufacturer’s instructions for installing his unit. The printer and terminal usually are linked together with a data cable which typically is no longer than six (6) feet (183 cm).
Some installations may require the terminal and printer to communicate via radio frequency
pg. 4 of 12 |