P4T/RP4T User Guide
Manual Introduction | RP4T Printers 35 | |
pg. | pg. | |
4 |
|
|
P4T Overview- pg. 5 | Maintenance pg. 36 | |
Printer Preparation pg. 7 | 38 | Troubleshooting pg. |
Connecting the Printer pg. 27 | 43 | Specifications pg. |
Radio Regulatory Information pg. 31 | Appendices pg. 46 | |
| Index pg. 52 |
Charging the P4T Series Battery with the
Figure 5- UCLI72-4 Quad Charger
Slide Battery Pack into a Charger bay
The
Battery Status | Charging Time |
80% charged | 2.5 Hrs. |
Full charge | 5 Hrs. |
Rock Battery Pack into place
• Ensure that the charger has been installed
Power Supplyproperly per the Quad Charger instruction manual. Ensure that the power indicator on
the front panel is on.
• Remove any protective
Plug a battery pack into any one of the four charging bays as shown opposite in Figure _,
noting the orientation of the battery pack.
• Slide the battery pack into the charging bay until it stops.
Fast |
|
| |
Charge | Full |
| |
Fault | Charge | ||
| |||
|
| Ready |
Fast |
|
| |
Charge | Full |
| |
Fault | Charge | ||
| |||
|
| Ready |
Fast |
|
| |
Charge | Full |
| |
Fault | Charge | ||
|
•Rock the battery pack back until it snaps into place.
The amber indicator directly under the bat- tery being charged will turn on if the battery is properly inserted.
|
|
| Ready | Charge | Full |
|
| The indicators under each battery will allow |
|
|
| Fast |
|
| |||
Amber | Green |
| Fault |
|
| Charge |
| you to monitor the charging process per the |
Charger |
| Power |
| Ready |
| |||
Indicator | Indicator |
|
|
|
| table below: | ||
Bay |
|
|
|
| Power Indicator | |||
|
|
|
|
|
|
|
Important • A fault condition (flashing amber indicator) is caused by a problem with the battery pack. The charger may indicate a fault because the battery is too hot or too cold to charge reliably. Try to charge the battery again when it returns to the room’s ambient temperature. If the amber indicator starts flashing on the second charging attempt, the battery should be discarded. Always dispose of batteries in a proper manner. Refer to Appendix E of this manual.
Amber | Green | Battery Status | |
On | Off | Charging | |
On | Flashing | 80% charged | |
|
| (O.K. to use) | |
Off | On | Completely | |
Charged | |||
|
| ||
Flashing | Off | Faulty Battery |
Notes: For more information regarding the installation and use of the
The
Section Continues | 15 |