Installing RW Series Batteries

Important • Batteries are shipped uncharged. Remove protective shrink-wrap and labels from new battery packs prior to use.

1.Rotate the Belt Clip to allow access to the Battery com- partment. This is an optional step on the RW 220.

2.Insert the battery into the printer as shown in Figure 3 or 4,

3.Rock the Battery into the printer as shown until it locks in

place.

When the battery is first installed, the Control Panel indicators may briefly turn on and then go off, indicating the battery is not fully charged (see “Charging the Battery” below and “Operator Controls.”)

Figure 5: LI 72 Single Charger

LI72 Charger

For best results, remove the Battery Pack while charging.

Charger Jack

Charging the Battery

The LI72 is a wall mounted fast charger with universal 110 to 230, 50-60 Hz. VAC input. Multiple A.C. plug configurations comply with most international standards. This charger is intended for use with the RW series printers which are equipped with Lithium Ion (Li-Ion) batteries.

continued

13

RW Series User Guide