Zebra Technologies RW SERIES Model UCLI72-4Quad Charger

Charging will cease three (3) hours after the charger has entered the “Maintain” mode.

Model UCLI72-4 Quad Charger

The UCLI72-4 Quad Charger is designed to charge up to four RW Series battery packs simultaneously. Batteries must be removed from the printer to be charged in the Quad Charger.

1.Ensure that the charger has been installed properly per the Quad Charger instruction manual. Ensure that the power indicator on the front panel is on.

2.Remove any protective shrink-wrap and labels from all battery packs prior to use. Plug a battery pack into any one of the four charging bays as shown in Figure 7, noting the orientation of the battery pack. Slide the battery pack into the charging bay until it stops. Then rock the battery pack back until it snaps into place. The amber indicator

Figure 7: UCLI72-4 Quad Charger

Power

1.Slide Battery Pack into Charger Bay

2. Rock Battery Pack into place

Fast
Charge	Full	Charge
Fault
		Ready
		Fast
		Charge	Full	Charge
		Fault
				Ready

Amber

LED

Fast Charge Fault

Full Charge

Ready

Fast
Charge	Full	Charge
Fault
		Ready

Green	Charger Bay
LED

Power

Power Indicator

16

RW Series User Guide