How do I adjust the water temperature?

The water temperature can be easily adjusted by using the variable thermostat control.

What is the purpose of the 'Economy' setting?

The 'Economy' setting maintains stored water temperature at approximately 60C to conserve energy.

What should I do if the safety cutout is triggered?

If the safety cutout is triggered due to over-heating, it should be reset by a Zenith Service Provider or licensed electrician, never by the user.

Operating Procedures, Spare Parts, Water Temperature

Operating Procedures

LOW

ANTI-

FREEZE

OFF

ECONOMY

HIGH

Water Temperature

Zenith Tudor water heaters are fully automatic, and may be left switched ON under the control of the variable thermostat.

Nominal operating temperature can be varied from about 30°C to about 80°C.

Temperature should not be set to less than 60°C without due regard to regulations governing the storage temperature of hot water.

Economy Setting

The economy setting "E" will maintain stored water temperature at approximately 60°C. At the "E" setting, the temperature control locates into a set position and a slight resistance will be felt when rotating the temperature control beyond that setting. This measure is to help ensure that higher temperatures are only selected deliberately.

Frost Protection

If the heater is located where ambient air temperature could fall below 5°C when the heater is not in use, the "anti freeze" setting on the temperature control will maintain stored water temperature over 5°C to prevent freezing and damage to the water heater.

The same protection does not extend to connecting pipework or fittings.

Safety Cutout

Should the heater over-heat, a manually resettable safety cutout will automatically turn the heating element OFF. The cutout must be reset by a Zenith Service Provider or a licensed electrician. Users should never reset the cutout without qualified assistance.

Cleaning

Never use strong, corrosive or abrasive cleaning materials. Wipe clean the outer surfaces with a sponge or soft cloth using a mild soap and water. Domestic dish washing liquid detergent is most suitable.

Spare Parts

PART NO DESCRIPTION

Z90401 element neck ring kit Tudor

Z90407 fascia kit Tudor undersink

Z90408 fascia kit Tudor oversink

Z90415 element kit Tudor 5ltr o/sink

Z90416 element kit Tudor 10ltr o/sink

Z90417 element kit Tudor 5ltr u/sink

Z90418 element kit Tudor 10ltr u/sink

Z90420 pilot light kit Tudor

Z90421 thermostat kit Tudor

Z90423 overload kit Tudor

PagePage6 6

ZenithZenithdorTudor- Installation- Installation& Operating& OperatingInstructionsInstructions- 81333- 81333- May- July20 - 2004

Zenith 216666666 Operating Procedures, Spare Parts, Water Temperature, Economy Setting, Cleaning

Models: 216666666