12
Connections (Continued)Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment.

RF coaxial connection

Connect the RF.OUTjack on the DVD+VCR to the
antenna in jack on the TV using the 75-ohm Coaxial
Cable supplied (R).
ote
If you use this connection, tune the TV to the
DVD+VCR’s RF output channel (CH 3 or 4).
How to set the DVD+VCR’s RF output channel
1.While the DVD+VCR is turned off,
press and hold CH
(v/V) on the front panel for about five
seconds.
The unit will turn itself on and “RF 03” or “RF 04” appears in
the display window.
2.
Use CH (v/V) on the front panel or v/Von the
remote control to change the RF output channel (CH
03 or CH 04).
3.
Turn off and on the DVD+VCR.

Audio/Video connection

11
Connect the DVD/VCR VIDEO OUT jack on the
DVD+VCR to the video in jack on the TV using the
video cable supplied (V).
22
Connect the Left and Right DVD/VCRAUDIO OUT
jacks on the DVD+VCR to the audio left/right in
jacks on the TV (A1) using the supplied audio
cables.
ote
If you use this connection, set the TV’s source selector
to VIDEO.
Optional, Preferred TV Connections
otes
You can watch and listen ONLY to DVD playback
through the connections shown below.

S-Video connection

11
Connect the S-VIDEO OUT jack on the DVD+VCR
to the S-Video in jack on the TV using an optional
S-Video cable (S).
22
Connect the Left and Right AUDIO OUTjacks of
the DVD+VCR to the audio left/right in jacks on the
TV using the supplied audio cables (A2).

Component Video (Color Stream®) connection

11
Connect the COMPONENT VIDEO OUT jacks on
the DVD+VCR to the corresponding in jacks on the
TV using an optional YPb Pr cable (C).
22
Connect the Left and Right AUDIO OUTjacks of
the DVD+VCR to the audio left/right in jacks on the
TV (A2) using the supplied audio cables.
L
R
AUDIO INPUT VIDEO
INPUT
ANTENNA
INPUT
Rear of TV
Rear of DVD+VCR
A1 VR
L
R
Y
Pb
Pr
COMPONENT VIDEO INPUT AUDIO INPUT
S-VIDEO
INPUT
Rear of TV
Rear of DVD+VCR
S A2C