Operating Instructions
Automaticshutoff
The dehumidifier will turn off automatically when the bucket is full, or when the bucket is removed or not replaced in the proper position.
The bucket must be replaced in the proper position for the dehumidifier to work. The light will be on and the dehumidifier will not run if the bucket is not in the proper position.
Water level
control switch
Disposingof collectedwater
1. Empty the bucket manually. | 2. Attach a length of garden hose to the threaded drain hose |
| connection to carry water to the drain. |
When the bucket is full, pull out by grasping the handle and empty it into a large sink or tub and then replace it properly.
NOTICE Do not remove while operating the dehumidifier.
It can cause water to drop on the base pan or the floor.
Empty the bucket when the indicator light turns on.
NOTICE It is advisable to carry the bucket by supporting it from the bottom as well as by the handle. Carrying by only the handle may
1.Connect a garden hose to the threaded drain hose connector. (Fig1)
2.Remove the
3.Push hose connector tightly into the
DRAIN HOLE
COVER
Fig2
HOSE
CONNECTOR
Fig1
HOSE
CONNECTOR
cause the handle or bucket cover to break.
4.Press the hose down and make sure the “Arrow” is pointing upward.
5.The connection should be resemble Fig5 when complete.
NOTICE The hose attachment will accept a standard garden hose fitting.
Do not over tighten the hose when connecting it to the hose connector, use a rubber washer and tighten by hand firmly without stripping the plastic threads.
INSERT | TAKE OUT |
|
Fig5
When being attached to hose connector drain hose connection, do not bend or kink the hose. The hose should lie flat fom the dehumidifier to the drain.