Zenoah BK3410FL-S, BK4310FL-S SE10 Bar Holder B Holder a, SE13 Arbor bolt Holder B Holder a

5. Set up

(Note that this is a left-turning screw.)

SE10

(1) Bar

(2) Holder B

(3) Holder A

2.Attach the cover (SE11,(11)) and fix it with screw.

3.Insert blade between cutter holder A and cutter holder B. (SE11)

4.Attach cover and spring washer. (SE11)

5.Screw the bolt to fix them into place. (SE11)

Tightening torque:

14.7~19.6 N-m (150~200kgf-m)

■LINE HEAD (SE11) (SE13)

IMPORTANT

Since the resistance of the nylon cutter is larger than that of the metal cutter, wrong operation of the nylon cutter will cause the clutch to overheat, deform and be damaged. When using the nylon cutter, carefully note the following.

•Use ZENOAH’s genuine nylon cutter. When using a commercially-available nylon cutter, make sure that it is no longer than 10 cm in external shape.

•Make sure that the length of the nylon cord is 17 cm or shorter.

•Keep the engine rotating at high speed while working.

1.	Detach bolt (1), spring washer (2), washer(3), bolt
	cover (4) and cover (11).
2.	Put holder B (5) to holder A (9).
	Screw arbor bolt (12) in holder B (5).

SE11

IMPORTANT

(1)Bolt

(2)Spring Washer

(3)Washer

(4)Bolt cover

(5)Holder B

(6)Blade

(7)Gear shaft

(8)Bar

(9)Holder A

(10)Gear case

(11)Cover preventing grass from getting caught up

3. Then attach the cutting head to the gear shaft over

the holders. Hard-tighten it securely.

SE13

(1) Arbor bolt

(2) Holder B

(3) Holder A

Look at the blade from above, and make sure that the direction in which the blade is mounted is correct. (SE12)

SE12

(1) Rotating direction

11