Cisco Systems ASA 5500 manual Installing the SFP Modules, •SFP Module, page

Chapter 3 Installing Optional SSMs

Cisco 4GE SSM

Step 4 Insert the Cisco 4GE SSM through the slot opening as shown in Figure 3-3.

Figure 3-3 Inserting the Cisco 4GE SSM into the Slot

LNK	3
	2
	1

Cisco SSM

POWER

STATUS

MGMT USB2 USB1

LINK	SPD	LINK	SPD
3				LINK	SPD
		2				LINK	SPD
				1
						0

		FLASH
ER	S
W
PO	STATU	ACTIVE VPN	FLASH

132984

Step 5 Attach the screws to secure the Cisco 4GE SSM to the chassis.

Step 6 Power on the adaptive security appliance.

Step 7 Check the LEDs. If the Cisco 4GE SSM is installed properly the STATUS LED flashes during boot up and is solid when operational.

Step 8 Connect one end of the RJ-45 cable to the port and the other end of the cable to your network devices. For more information, see “Chapter 4, “Connecting Interface Cables.”

Installing the SFP Modules

The SFP (Small Form-Factor Pluggable) is a hot-swappable input/output device that plugs into the SFP ports. The following SFP module types are supported:

•Long wavelength/long haul 1000BASE-LX/LH(GLC-LH-SM=)

•Short wavelength 1000BASE-SX (GLC-SX-MM=)

This section describes how to install and remove the SFP modules in the adaptive security appliance to provide optical Gigabit Ethernet connectivity. This section contains the following topics:

•SFP Module, page 3-5

•Installing the SFP Module, page 3-6

	Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
3-4	78-17611-01