Cisco Systems ASA 5500 manual Cabling 4GE SSM Interfaces, 11-2

Chapter 11 Configuring the 4GE SSM for Fiber

Cabling 4GE SSM Interfaces

Cabling 4GE SSM Interfaces

To cable 4GE SSM interfaces, perform the following steps for each port you want to connect to a network device:

Step 1 To connect an RJ-45 (Ethernet) interface to a network device, perform the following steps for each interface:

a.Locate a yellow Ethernet cable from the accessory kit.

b.Connect one end of the cable to an Ethernet port on the 4GE SSM as shown in Figure 11-1.

Figure 11-1 Connecting the Ethernet port

LNK 3

2	1
	0	SPD
4GE		POW	ER	STATUS

1

MGMT USB2 USB1 MGMT USB2

143597

1

RJ-45 (Ethernet) port

c.Connect the other end of the cable to your network device.

Step 2 (Optional) If you want to use an SFP (fiber optic) port, install and cable the SFP modules as shown in Figure 11-2:

a.Insert and slide the SFP module into the SFP port until you hear a click. The click indicates that the SFP module is locked into the port.

b.Remove the optical port plugs from the installed SFP.

c.Locate the LC connector (fiber optic cable) in the 4GE SSM accessory kit.

d.Connect the LC connector to the SFP port.

	Cisco ASA 5500 Series Adaptive Security Appliance Getting Started Guide
11-2	78-17611-01