5. Set up
2.Attach the lever as shown in the picture and screw it securely. (SE6)
SE6
(1) Throttle lever
(2) Hole
(3) Throttle cable
(4) Screw
(5) Nut
SE8
WARNING
(1)Loop handle
(2)Screw
(3)Washer
(4)Nut
(5)Throttle lever
(6)Right hand grip
■ADJUSTING THROTTLE CABLE
• Proper play of the throttle cable is |
throttle lever to the lowest speed position (i.e. fully |
released status). Pull the throttle cable lightly with |
fingers to check its play. Readjust the position of |
Stop tightening the screws when the gap A becomes zero.
■ATTACHING THE DEBRIS GUARD
WARNING
Never use the machine without the debris guard.
•Attach the guard to the clamp on the outer pipe just touching the gearcase. Fix it with 2 bolts. (SE9)
cable adjuster if the play is too large or too small. To |
readjust, slacken a lock nut. Turn the cable adjuster |
clockwise to increase the play, or counterclockwise to |
decrease the play. Lock the cable adjuster with the |
lock nut after readjustment. (SE7) |
SE7
(1) Cable adjuster
(2) Lock nut
(3) Throttle cable
SE9
■BLADE
WARNING
(1)Bolt (M5x25)
(2)Clamp
(3)Debris guard
(4)Place to be attached for blade use
(5)Place to be attached for line head
■ATTACHING THE HANDLE
NOTE
The loop handle should be located between the arrow mark and the throttle lever.
•Attach the loop handle as shown in the accompanying diagram. Note that it is recommended that you attach the handle so that the handle is located some
•Do not install or remove the blade while the engine is in operation.
•Use ZENOAH’s genuine replacement blades and metal fixtures when installing the blade.
•When installing or removing the blade, fix the machine securely, and wear robust gloves.
•The blade turns counterclockwise (viewed from the gear case). When using an
1.Loosen the bolt remove holder A and holder B from the gear case. (SE10)
10
