5.While holding the saw unit securely on the ground, pull the starter rope vigorously.
Do not start the engine while hanging the chain saw with a hand. The saw chain may touch your body. It's very dangerous.
6.When engine has ignited first, push in the choke knob and pull the starter again to start the engine.
7.Allow the engine to warm up with the throttle lever pulled slightly.
Keep clear of the saw chain as it will start rotating upon starting of engine.
Checking oil supply
After starting the engine, run the chain at medium speed and see if chain oil is scattered oft as shown in the figure.
The chain oil flow can be changed by inserting a screwdriver in the hole on bottom of the clutch side. Adjust according to your work conditions.
Note:
The oil tank should become nearly empty by the time fuel is used up. Be sure to refill the oil tank every time when refueling the saw.
Adjusting carburetor
The carburetor has been adjusted at the factory. Should your unit need readjustment due to the changes in altitude or operating conditions, please let your skillful dealer make the adjustment. A wrong adjustment may cause damage to your unit. If you have to make the adjustment yourself, please carefully follow the procedure below.
Note :
Be sure to adjust the carburetor with the bar chain attach ed.
7
