Bradford-White Corp MAGNUM Series Commercial Electric Booster Accessories, Shock Absorber, System

		ACCESSORIES
Stainless Steel Adjustable Legs		Floor Mounting Hardware
1. Carefully place the unit on its side.		Stainless steel adjustable legs with deck mounting flange are
		available for securing the booster heater to the floor.
	NOTICE	Shock Absorber
Do not lay unit on the side with the control panel. Damage		The shock absorber installed between the booster and the
to the unit could occur.		commercial dish machine reduces water hammer induced by
2. Thread the adjustable legs into the existing leg holes on		rapidly operating valves. The water hammer can cause damage
the bottom of the unit.		to the equipment.
3. After all legs are secure, return the unit to the upright		Blended Phosphate Water Treatment
position.		System
NOTE: If unit is not level, use an adjustable open-end wrench		The Blended Phosphate Water Treatment System is installed
to adjust the foot of each leg until unit is level. Each leg		before the booster water heater and reduces mineral scale
is adjustable from 6″ (152 mm) to 7″ (178 mm).		build-up by introducing a measured amount of polyphosphate
		into the water.
		Bradford White recommends that the Blended Phosphate Water
		Treatment System be installed with unions on the incoming 3/4"
		water supply line after the pressure reducing valve and before
		the booster water heater.
		Cartridges supplied have a usage rating of 100,000 gallons
		(378,541 liters) of water. To assure proper operation the
		cartridges must be replaced when expired.
		NOTE: Product failure caused by liming or sediment buildup is
Figure 14. Optional Stainless Steel Adjustable Legs		not covered under warranty.

Form No. EBOOSTERBWM-1009 17