Zenoah CHTZ7500, CHTZ6000 owner manual Symbols On The Machine, English, Cleaner, Gear Case, Blades

English

WARNING

1.CLEANER

Please inspect the cleaner every day for dirt. Please clean out any dust that is found up to the element on the carburetor side. When rebuilding the cleaner, be

sure to follow the following order: element → felt → element. If

dust remains on the cleaner when it is used, the dust may enter the engine, cause abrasion in the pistons, and lead to engine damage.

2.GEAR CASE

Please re-supply the gear case with grease every 25 hours. Grease must be added every day if the unit is used in dusty areas. Grease should be added until the old grease emerges. Dirty grease is a cause of internal abrasion.

3.BLADES

Please replace the blades if the space between them becomes 0.7mm or more. This is because dust may enter the gear case and cause abrasion.

2. SYMBOLS ON THE MACHINE

For safe operation and maintenance, symbols are carved in relief on the machine. According to these indications, please be careful not to take a mistake.

(a).The port to refuel the "MIX

GASOLINE"

POSITION: FUEL TANK CAP

(b).The direction to close the choke

POSITION: AIR CLEANER COVER

(c).The direction to open the choke

POSITION: AIR CLEANER COVER

5