Zenoah KAM-402 owner manual Installing Blade, SE8, SE7 Blade, Balance Unit, SE9

5. Set up

■INSTALLING BLADE

Remove the guard skirt of debris guard, when using metal blade.

1.Put the hexagonal bar into the side holes of the holder A and the gearcase.

2.Remove the nut(Left-handed) and the holder B from the gearshaft.

3.Put the blade onto the holder A. Make the marked side face the holder.

4.Put the holder B onto the gearshaft making the recessed side face the blade.

5.Fasten the blade by the nut and the cover.

IMPORTANT

Look at the blade from above, and make sure that the direction in which the blade is mounted is correct. (SE8)

SE8 (1) Rotating direction

SE7

■BLADE

WARNING

(1)Hexagonal bar

(2)Holder A

(3)Holder B

(4)Cover

■BALANCE UNIT

1.Put on strap and attach unit to strap.

2.Slide clamp up or down until unit balances with head aparting from the ground when using it.

SE9

•Do not install or remove the blade while the engine is in operation.

•Use ZENOAH’s genuine replacement blades and metal fixtures when installing the blade.

•When installing or removing the blade, fix the machine securely, and wear robust gloves.

•The blade turns counterclockwise (viewed from the gear case). When using an inside-out blade, check the direction of the blade before installing it. In particular, if you install a chip saw in the wrong direction, the chips might break and scatter.

10