8. Maintenance

WARNING

Make sure that the engine has stopped and is cool before performing any service to the machine. Contact with moving cutting head or hot muffler may result in a personal injury.

AIR FILTER

The air filter, if clogged, will reduce the engine performance. Check and clean the filter element in warm, soapy water as required. Dry completely before installing. If the element is broken or shrunk, replace with a new one.

MA1

(1) Air filter

 

 

FUEL FILTER

When the engine runs short of fuel supply, check the fuel cap and the fuel filter for blockage.

IMPORTANT

Note that using any spark plug other than those designated may result in the engine failing to operate properly or in the engine becoming overheated and damaged.

To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn more with a socket wrench.

Tightning torque: 9.8~11.8N.m. (1.0~1.2kgm))

MA4

GEAR CASE

The reduction gears are lubricated by multipurpose,

 

lithium-based grease in the gear case. Supply new

 

grease every 25 hours of use or more often

 

depending on the job condition.

Remove the bolt opposit to the grease nipple before

 

installing new grease to arrange for old grease to exit.

MA2

SPARK PLUG

(1) Fuel filter

MA5

(1) Bolt

 

 

(2) Grease nipple

 

(1)

 

(2)

Starting failure and misfiring are often caused by a fouled spark plug. Clean the spark plug and check that the plug gap is in the correct range. For a replacement plug, use the correct type specified by ZENOAH.

REPLACEMENT PLUG IS A NGK BPMR7A.

MA3

0.6~0.7mm

INTAKE AIR COOLING VENT

WARNING

Never touch the cylinder, muffler, or spark plugs with your bare hands immediately after stopping the engine. The engine can become very hot when in operation, and doing so could result in severe burns.

When checking the machine to make sure that it is okay before using it, check the area around the muffler and remove any wood chips or leaves which have attached themselves to the brushcutter. Failing to do so could cause the muffler to become overheated and that in turn

15

Page 15
Image 15
Zenoah KAM-402 owner manual Maintenance