www.zephyronline.com
– Remote Blower Preparation
B
1. Place 8” round adapter on top of power pack | 2. Install threaded end of remote blower wiring |
and secure with (4) M4x8 screws. Connect 8” | through external blower wiring knock out (B) |
round duct work to 8” round adapter. | located in junction box on top of power pack. |
B
Installation
3.Place cap over threaded end of remote blower wiring and secure by turning clockwise.
4.Connect 6 pin male connector from blower wiring to 6 pin female connector in the power pack. (plug is located inside the power pack protruding from the white control board box).
A: Ground wire screw | A | |
location (inside) | ||
|
5.Secure green ground wire from remote blower wiring to ground screw located inside the power pack
Remote Blower | White (common) |
Black (high) | |
Wiring Box | Blue (med) |
(hood) | Red (low) |
| Green (ground) |
Junction Box
(Remote Blower)
NOTE: For instructions on installing remote blowers, please refer to the
12