Installation
22.Install duct cover with 2 screws first on duct cover support bracket, then slide the duct lower section towards the bottom.
23.Fit control ball with its molex plug on its housing and twist in place.
a
b
˜ 15°
c
OK! 
24.Perform connection between plates from control ball and from electronic box.
25.Fold all cables and plate so to avoid any damage when sliding the lower duct cover towards the bottom.
26 Fix lower duct cover to canopy with 2 screws.
Duct cover support bracket
TOP
VIEW
Upper
Duct coverduct cover support bracket
Plate from electronic box
|
| Control Ball |
Lower | ||
| duct cover | Housing |
Control Ball
Note! consider this drawings as installation aid, dimensions are not respected.
27.Check all light bulbs to make sure they are secure in their sockets.
Turn power on in service panel. Check lights and blower operation.
If range hood does not operate:
•Check that the circuit breaker is not tripped or the house fuse blown.
•Disconnect power supply. Check that wiring is correct.
14
