Zephyr GU4/MR11 Remote Control, 2.1SYNCHRONISATION, 2.2OPERATION, 2.3GENERAL INFORMATION, Lights

2.1SYNCHRONISATION:

To synchronise the remote control with the range hood for the first time, proceed as follows:

1.With range hood off, press and hold the “lights” button on the range hood until the light indicator begins to flash. Fig.1

2.Rotate the upper part of the remote control until the“lights” indicator light on the range hood switches off. Fig. 2

The range hood may now be activated using the remote control. If you experience any problems, repeat the procedure.

2.2OPERATION:

- BLOWER SPEED:

The blower speed may be adjusted by rotating the upper part of the remote control and aligning the marker with the desired speed. Fig. 2

0= Off

1= Low

2= Medium

3= High

- LIGHTS:

The lights may be switched on by pressing the remote control. Fig. 3

The brightness may be progressively reduced by pressing it a second or third time.

The fourth time the remote control is pressed, the lights will be switched off.

2.3GENERAL INFORMATION:

-The remote control has a range of approximately 15-20 feet.

-The remote control is equipped with a magnetic base and may therefore be attached to ferrous surfaces.

-BATTERY REPLACEMENT:

The battery will last for approximately 12-15 months, depending on usage.

1.Remove the rubber cover as shown in Fig. 4

2.Remove the battery by pressing the side of it. Fig. 5

3.Replace the battery with a 3 volt type 5004LC / CR 2032

2. Remote Control

- 7 -