Zhumell RF645 Film Memo Holder, How to Remove a Used Roll of Film, 100 200 400 800, 25 26 28 29

2. Preparing to Shoot 2-4 Exposure Counter

2-4 Check the number on the exposure counter 2-4-1 Exposure Counter

The exposure counter resets itself to "S" (start) position as the camera back is opened. When the fresh film is loaded and advanced to the first frame, the exposure counter displays "1". The counter indicates all odd numbers with consecutive numerals and all even numbers with dashes. After 16 pictures shot with 120 type film, the advance lever is released from frame positioning lock and can wind continual- ly without stopping. The exposure counter advances to 17, -, 19 and stops only when the film's trailing paper is fully wound into the take- up film chamber. In the case of 220 type film, the rapid wind lever is released when the film is fully used, and the exposure counter dis- plays "E".

ISO speed	25 32 40 50 64 80 100 125 160 200 250 320								400 500 640		800 1000 1250		1600
Film speed	25	I I	50	I I	100	I I	200	I I	400	I I	800	I I 1600
dial scale
DIN speed	15	16 17	18	19 20	21	22 23	24	25 26 27		28 29 30		31 32	33

2-4-2 Film Memo Holder

It may be necessary to reconfirm the type of film being used in the heat of a photo shooting session. To facilitate this, clip off the top or bottom flap of the film box and insert it into the memo holder locat- ed on the rear cover of the camera. Make sure to replace the film box flap when a new roll of film is loaded.

2-4-3 How to Remove a Used Roll of Film

1.The film advance lever will be released from the frame positioning lock mechanism and wind continually after the 16th frame in the case of 120 type film and the 32nd frame in the case of 220 type film, until the trailing paper is fully wound into the take-up film chamber. At that point, all the torque is removed from the film advance action.

2.Press the rear cover lock release of the camera upward to open the rear cover. Press down on the film spool shaft lock release button and push the top of the film spool lightly as illustrated and remove the spool from the film chamber. Hold the film roll so that film's trailing light shielding paper does not make slack, and seal the film tightly with the adhesive paper band attached to the film trailing paper.

12