Testing ZX222 Adapters in DOS
1.Run the diagnostic program that came with your adapter to see if your adapter has been properly configured. Run DIAG222.EXE off your diskette by entering:
>DIAG222 LIST
2. You will see a list below.
DIAG222 Version x.xx for ZNYX NetBlaster ZX222 2/100 Mbps adapter
(c) Copyright 2000 ZNYX Corporation - All Rights Reserved.
PCI BIOS Information: Version=2.10, Config Mechanism=1, Last Bus=2
Bus | Dev | Fn | Vendor Device | Rev | Type | Lat IL IRQ | Note | |||
========== | ================= | ============ | ========== | ===== | ||||||
0 | 0 | 0 | 8086 | 1250 | 03 | Host Bridge | 20 | - | - |
|
0 | 7 | 0 | 8086 | 7000 | 01 | PCI | 00 | - | - |
|
0 | 7 | 1 | 8086 | 7010 | 00 | IDE | 20 | - | - |
|
1 | 5 | 0 | 1011 | 0019 | 30 | Ethernet | 40 | A | 3 | ZX222 |
1 | 6 | 0 | 1011 | 0019 | 30 | Ethernet | 40 | A | 10 | ZX222 |
3.You should see two
4.To test all channels of your adapter, run DIAG222 for each bus number and device number. For example, if you have a ZX222 and the bus number is 1 and the device numbers are 4 and 5, run:
>DIAG222 1 4 >DIAG222 1 5
5.If the DIAG222 program says:
Diagnostics successfully compl eted.
each time, proceed with the software installation.
System-Specific Configuration Requirements
The host computer program should automatically assign all system resources, such as I/O addresses and interrupt lines (IRQ).
Basic Troubleshooting
For all operating systems, we recommend that you try the following if you are having difficulty.
1.Make sure the board is securely seated in the slot.
2.Observe the LED’s. Each port on the ZX222 has a LINK (green) LED and an ACTIVITY (amber) LED. The green LED illuminates upon successfully establishing a link. The amber
ZNYX Networks NetBlaster ZX222 PMC Fast Ethernet Adapter · User’s Guide | Page 6 |
