Using the Expression Pedal (FP01/FP02)

The 504 II is equipped with a CONTROL IN jack designed for connection of the optional expression pedal FP01 or FP02. The pedal can be used as volume pedal or as a controller for varying effect parameters.

For information on parameters that can be adjusted with the expression pedal, please refer to pages 26 - 29.

1. Plug the cable from the FP01/FP02 into the CONTROL IN jack of the 504 II, and then turn the 504 II on.

If the FP01/FP02 is plugged into the CONTROL IN jack while the 504 NOTE II is already on, malfunction may occur. Be sure to turn on the 504 II

only after connecting the expression pedal.

Restoring Factory Defaults

The 504 II comes with 36 preprogrammed patches. These factory default patches can be restored also if they were overwritten by patches created by the user.

There are two ways of restoring factory defaults. "All Initialize" returns the entire set of patches to the original condition. "Factory Recall" restores a specific patch to the original condition.

1. While holding down the STORE key, plug the appropriate cable into the INPUT jack (or DC 9V jack).

The indication "AL" flashes on the display.

To perform All Initialize
2. Press the STORE key once more.

All patch settings are returned to the factory default condition, and the unit switches to play mode. To cancel All Initialize, press the [-] key.

2. Select the patch in play mode, and

 

move the expression pedal back

 

and forth while playing your

Move back and forth

instrument.

 

NOTE

All user-created patches will be lost when performing All Initialize. Use this function with care.

Restoring

Pedal Expression the Using

Depending on the program content of the patch, the volume or effect parameter will change.

The expression pedal can also be used in edit mode to control the volume or effect parameter.

To perform Factory Recall

2. Use the []/[ ] foot switches to select the patch you want to return to the original condition.

The specified bank and patch number are flashing on the display.

During Factory Recall, the [+]/[-] keys cannot be used to switch the bank only.

3. Press the STORE key once more.

The settings of the specified patch are returned to the factory default condition.

If desired, repeat steps 2 and 3 to restore other patches. To terminate the Factory Recall operation, press the [-] key. The unit will switch to the play mode at this point.

Defaults Factory

20 ZOOM 504 II ACOUSTIC

ZOOM 504 II ACOUSTIC 21