Method Call" "Patch the Changing

Changing the "Patch Call" Method

In normal operation, the sound of the 504 II will change immediately if a patch is selected in play mode. This may be undesirable if a patch from a distant memory location is called and the sound of other unwanted patches in between is heard. If desired, you can change the "Patch call" method from direct selection to the pre-select method. In pre-select mode, you first specify the desired patch and then confirm the selection. The sound will only change after you have confirmed the operation.

Changing the "Patch call" method to pre-select

To change the "Patch call" method to pre- select, you must turn the unit on while holding down the [] foot switch.

Specifying the desired patch

Use the [ ]/[ ] foot switches to select the patch you want to use next.

You can also use the [+]/[-] keys to only switch the bank.

The bank and patch number of the patch to be used next will be shown on the display, but the sound does not yet change.

Changing the "Patch Call" Method

Confirm the patch change

When the desired patch is shown, press the [ ]/[] foot switches together.

Confirm

Changing

 

The patch change is

 

confirmed, the sound

the

changes, and the display

 

stops flashing and stays

Call""Patch

Changing the "Patch

constantly lit.

 

call" method back to

Method

 

direct select

To change the "Patch call" method back to normal direct select operation, simply turn the unit off and back on again.

This will return the patch select method to the default setting.

16 ZOOM 504 II ACOUSTIC

ZOOM 504 II ACOUSTIC 17