Editing a Patch
The patches of the 504 II can be freely edited by changing the effect parameter settings. Try editing the currently selected patch to create your own sound.
Select the effect parameter
Use the [PLAY/EDIT] selector to select the effect you want to change.
The value of the currently | Parameter | ||
value | |||
selected parameter is |
|
|
|
|
|
| |
shown on the display. |
|
|
|
|
|
| |
(When the 504 II is in edit |
|
|
|
mode, a dot (.) is shown in |
|
|
|
the bottom right section of |
|
|
|
the display.) |
| Lit | |
Parameters selectable with [PLAY/EDIT] selector
(1)Patch level
(2)TYPE parameter
(3)LIMIT/EDGE parameter
(4)LOW/BODY parameter
(5)HIGH/TOP parameter
(6)AIR parameter
(5)| (4) | (6) | (7) | EFFECT parameter |
| |
| (3) | (7) | (8) | DLY&REV parameter |
| |
(9) | ) | ||||
(2) | (8) | (10) F.B.SUPPRESSOR |
| ||
| (1) | (9) |
| parameter ( | ) |
|
|
|
|
| ||
(10) | = global parameter |
|
Change the parameter value
Use the
Holding down one of these keys will continuously change the value. Additionally pressing the opposite key will cause a faster change. Pressing both keys simultaneously skips values in larger steps.
Changing the parameter on/off condition
Press both [
]/[
] foot switches together.
The parameter is turned off, and the indication "oF" appears on the display. Pressing both foot switches together once more turns the parameter on again.
This operation is not possible for the patch
level and TYPE parameters (step 
, parameters (1) and (2)).
Terminate the edit mode
To terminate the edit mode and return to the play mode, set the [PLAY/EDIT] selector to the "PLAY" position.
Unless you store the edited patch in memory, the NOTE settings you made will be lost when you select a
different patch after returning to the play mode. Do not forget to store an edited patch that you wish to keep, as described on page 14.
Patch a Editing
12 ZOOM 504 II ACOUSTIC | ZOOM 504 II ACOUSTIC 13 |