Convenient Recording Functions
ZOOM H2
43
function cannot be used together. If you set
one of these functions to ON while the other is
already ON, the earlier function will
automatically be turned OFF.
4.

Carry out recording.

Press the
5
(REC) key to set the H2 to the
recording standby condition. When you then
press the
5
(REC) key again to begin
recording, the pre-recorded part from
immediately before that point will also be
included.
The duration of the pre-recorded part depends
on the operation mode, file format and
sampling frequency, as shown below.

Stereo mode

4-channel mode

Recording a stereo signal in mono (stereo mode only)
The H2 allows you to record a signal from
the internal or external mics or from an
external component in mono. This can be
useful for example for narration or effect
sounds, where handling the material in
mono may be preferable.
NOTE
• The steps described below will cause the
stereo channel signals of the internal or
external mics or an external component to
be mixed. The result is then recorded as a
stereo file where the L and R channels have
the same content.
• This function is available in stereo mode
only.
1.
Bring up the main menu screen.
At the stereo mode or 4-channel mode top
screen, press the
4
(MENU) key.
2.

Bring up the MONO MIX screen.

Repeatedly press the
3
(REW)/
2
(FF)
keys to move the cursor to "MONO MIX" and
press the
5
(REC) key.
3.

Set the MONO MIX function to

ON.

Use the
3
(REW)/
2
(FF) keys to move the
cursor to "ON", and press the
5
(REC) key.
File format/Sampling frequency
Time
WAV 44.1 kHz
2 seconds
WAV 48 kHz
WAV 96 kHz
1 second
MP3
2 second
File format/Sampling frequency
Time
44.1 kHz
1 second
48 kHz
H2-E.fm 43 ページ 2007年7月11日 水曜日 午後3時19分