ZOOM H2
89
Error Messages
Card related messages Cause Remedy
No Card
No SD card is inserted. Insert SD card and turn power on.
No File
A valid file was not found.
Card Format Error!
SD card formatting process failed, or card
was not recognized normally. *
Card Full!
Card became full during recording
File name exists!
File name change was attempted, but file
with same name already exists. Specify a different file name.
Stop Recorder!
User attempted to access a menu not
available during playback or recording. Stop the recorder operation first.
Card Protected
The SD card is write-protected. Change setting of card's write-
protect switch.
Format Card?
SD card with incorrect format was inserted.
When you select "YES" at this
screen and then press the
5
(REC)
key, all data are erased and
initialization is carried out.
Now Recording!
User attempted to access a menu not
available during recording or recording
standby.
Stop recording first.
File Create Error!
The file could not be created at start of
recording. *
Card Error!
A card error has occurred.
File Protected
User attempted to write to a read-only file
from the file menu.
Change the read-only file attribute
using a computer.
File Rename Error!
A blank or invalid file name was specified
during file name editing. Do not use invalid characters.
Card Write Error
Shown when an error occurs during file
write other than recording. *
Card Read Error!
Shown when an error occurs when opening a
file.
Data Write Error
Shown when data transfer to SD card cannot
keep up with data stream during recording.
Reduce sampling frequency and/or
number of bits.
* If card related error messages occur frequently, the SD card may be defective.
Other messages Cause Remedy
RESET DATE/TIME
The internal clock was reset because battery
backup was interrupted.
Set the date and time again. The
internal clock requires batteries to be
inserted.
Low Battery!
Battery voltage is low. Replace batteries.
Please Power Off
Shutdown procedure is complete. Set power switch to OFF.

Please pull out external input

When external mic or component is
connected, mic pattern cannot be selected. Disconnect any external mic or
component connected to [EXT MIC
IN] or [LINE IN] jack.
Only Built-in MIC is active
External mic or component is connected,
although only built-in mic is active in 4-
channel mode.
Invalid File!
An invalid file was specified. Select a valid file.
H2-E.fm 89 ページ ２００７年７月１１日　水曜日　午後３時１９分