Manuals / Brands / Computer Equipment / Network Card / ZyXEL Communications / Computer Equipment / Network Card

ZyXEL Communications 2002 Series System Screens, 3.1 System Overview, 3.2 General Setup, 3.3 General Setup Configuration, 3.2.1Domain Name, Start, Start, Start, SYSTEM, System, SYSTEM, Network

1 102

Download 102 pages, 3.07 Mb

Prestige 2002 Series User’s Guide

CH A P T E R 3

System Screens

This chapter provides information on the System screens.

3.1 System Overview

This chapter describes the SYSTEM screens.

3.2 General Setup

General Setup contains administrative and system-related information. System Name is for identification purposes. However, because some ISPs check this name you should enter your computer's "Computer Name".

•In Windows 95/98 click Start, Settings, Control Panel, Network. Click the Identification tab, note the entry for the Computer Name field and enter it as the System Name.

•In Windows 2000, click Start, Settings and Control Panel and then double-click System. Click the Network Identification tab and then the Properties button. Note the entry for the Computer name field and enter it as the System Name.

•In Windows XP, click Start, My Computer, View system information and then click the Computer Name tab. Note the entry in the Full computer name field and enter it as the Prestige System Name.

3.2.1Domain Name

The Domain Name entry is what is propagated to the DHCP clients on the LAN. If you leave this blank, the domain name obtained by DHCP from the ISP is used. While you must enter the host name (System Name) on each individual computer, the domain name can be assigned from the Prestige via DHCP.

3.3 General Setup Configuration

Click SYSTEM in the navigation panel and then General Setup to display the following screen.

Chapter 3 System Screens

29

Contents

User’s Guide Page Copyright Disclaimer Trademarks Federal Communications Commission (FCC) Interference Statement Notice Certifications ZyXEL Limited Warranty Note Safety Warnings Customer Support Table of Contents Introduction to VoIP Phone Phone Book Maintenance Troubleshooting Appendix A Hardware Specifications Appendix B Appendix C List of Figures Page List of Tables Page Preface About This User's Guide Related Documentation User Guide Feedback Syntax Conventions Graphics Icons Key Introducing the Prestige 1.1 Prestige 2002 VoIP Analog Telephone Adaptor Overview 1.2Prestige 2002L VoIP Analog Telephone Adaptor with Lifeline 1.3 Features 10/100Mbps Auto-negotiatingFast Ethernet Interfaces PSTN Lifeline REN Dynamic Jitter Buffer Standards Compliance Multiple SIP Accounts 1.4 Applications 1.4.2 Make Calls via IP-PBX Page Page Introducing the Web Configurator 2.1 Web Configurator Overview 2.2Accessing the Prestige Web Configurator Apply Ignore MAIN MENU 2.3 Resetting the Prestige 2.4Navigating the Prestige Web Configurator Page 2.5 Common Screen Command Buttons Page System Screens 3.1 System Overview 3.2 General Setup 3.3 General Setup Configuration 3.4 Configuring Password 3.5 Pre-definedNTP Time Servers List 3.6 Configuring Time Setting Page Page Ethernet Screens 4.1 ETHERNET Overview 4.2 Configuring Ethernet Figure 10 ETHERNET Table 7 ETHERNET 4.3 Configuring the Ethernet Management Port Introduction to VoIP 5.1 Introduction to VoIP 5.2 Introduction to SIP 5.2.1.1 SIP Number 5.2.1.2 SIP Service Domain 5.2.3.1 SIP User Agent Server 5.2.3.2 SIP Proxy Server 5.2.3.3 SIP Redirect Server 5.2.3.4 SIP Register Server 5.3 STUN 5.3.2.1 Full Cone NAT 5.3.2.2 Restricted Cone NAT 5.3.2.3 Port Restricted Cone NAT 5.3.2.4 Symmetric NAT 5.4 SIP ALG 5.5 Pulse Code Modulation 5.6 Voice Coding 5.7 PSTN Call Setup Signaling VoIP Screens 6.1 VoIP Introduction 6.2 VoIP Configuration 6.3 Advanced VoIP Settings Configuration Page Page 6.4 Quality of Service (QoS) 6.4.2.1 DSCP and Per-HopBehavior 6.5 QoS Configuration Phone 7.1 Phone Introduction 7.2 Phone Port Configuration Figure 24 Phone Port Phone Book 8.1 Phone Book Introduction 8.1.1.1 Peer-to-PeerCalls 8.2 Speed Dial Configuration Figure 25 Phone Book 8.3 Lifeline Configuration (Prestige 2002L) Page Logs 9.1 Viewing Logs 9.1.1 Log Message Descriptions Table 19 SIP Logs Table 20 RTP Logs Page Maintenance 10.1 Maintenance Overview 10.2 Status Screen 10.3 F/W Upload Screen Firmware Upload in Process 10.4 Configuration Screen 10.4.1Backup Configuration Configuration Upload Error 10.4.3 Back to Factory Defaults Reset 10.5 Restart Screen Page Troubleshooting 11.1 Problems Starting Up the Prestige 11.2 Problems with the LAN or PC LED 11.3 Problems with the LAN Interface 11.4 Problems with Internet Access 11.5 Problems with the Password 11.6 Problems with the Web Configurator 11.7 Problems with Telephone or Telephone Port 11.8 Problems with Voice Service Appendix A Hardware Specifications Ethernet Port Specifications Prestige 2002 Power Adaptor Specifications Prestige 2002L Power Adaptor Specifications Appendix B Setting up Your Computer’s IP Address Windows 95/98/Me Installing Components Add Adapter Protocol Microsoft Configuring Obtain an IP address automatically Specify an IP address Subnet Mask DNS Windows 2000/NT/XP Network Connections Network and Dial-up Connections 3Right-click Local Area Connection and then click Properties Internet Protocol (TCP/IP) General Use the following IP Address IP address Subnet mask Default gateway Advanced Use the following DNS server addresses Preferred DNS server Alternate DNS server 8Click OK to close the Internet Protocol (TCP/IP) Properties window 9Click OK to close the Local Area Connection Properties window Macintosh OS 8/9 Macintosh OS Automatic Location •Select Built-inEthernet from the Show list Using DHCP Apply Now Appendix C IP Subnetting IP Addressing IP Classes Subnet Masks Subnetting Example: Two Subnets Page Example: Four Subnets Example Eight Subnets Subnetting With Class A and Class B Networks Page Appendix D PPPoE PPPoE in Action Benefits of PPPoE Traditional Dial-upScenario How PPPoE Works Prestige as a PPPoE Client Index