Prestige 202H Plus Quick Start Guide
| Table 4 Adding/Editing Source and Destination Addresses |
|
|
LABEL | DESCRIPTION |
|
|
Address Type | Do you want your rule to apply to packets with a particular (single) IP address, a range of IP |
| addresses (e.g., 192.168.1.10 to 192.169.1.50), a subnet or any IP address? Select an option |
| from the drop down list box |
|
|
Start IP Address | Enter the single IP address or the starting IP address in a range here. |
|
|
End IP Address | Enter the ending IP address in a range here. |
|
|
Subnet Mask | Enter the subnet mask here, if applicable. |
|
|
6 Troubleshooting
PROBLEM | CORRECTIVE ACTION |
|
|
None of the LEDs turn | Make sure that you have the correct power adaptor connected to the Prestige and plugged |
on when you turn on | in to an appropriate power source. Check all cable connections. |
the Prestige. | If the LEDs still do not turn on, you may have a hardware problem. In this case, you should |
| |
| contact your local vendor. |
|
|
Cannot access the | Check the cable connection between the Prestige and your computer or hub. |
Prestige from the LAN. | Ping the Prestige from a LAN computer. Make sure your computer Ethernet adapter is |
| |
| installed and functioning properly. |
|
|
Cannot ping any | If the LAN LEDs are all off, check the cable connections between the Prestige and your |
computer on the LAN. | LAN computers. |
| Verify that the IP address, subnet mask of the Prestige and the LAN computers are in the |
| same subnet. |
|
|
Cannot access the | Verify the Internet connection settings in the WAN screen. |
Internet. | The user name and password are case sensitive. Make sure you entered the correct user |
| |
| name and password. |
|
|
24