ZyWALL 35 Internet Security Appliance

4.If you want to set up a backup WAN connection, connect the 9-pin female end of your modem or Terminal Adaptor (TA) cable to DIAL BACKUP port and the other end to your modem or TA.

5.If you want to configure the ZyWALL using the SMT (System Management Terminal) via CONSOLE port, connect the 9-pin male end of the console cable to the console port of the ZyWALL and the other end to a serial port (COM1, COM2 or other COM port) on your computer.

6.After you’ve made the connections, connect the included power adaptor to the power socket and connect the power adaptor to a power supply (outlet).

The PWR LED turns on green when you connect the power. The SYS LED blinks for about 30 seconds while performing system testing and then stays on if the testing is successful. The ACT, CARD, WAN and LAN/DMZ LEDs turn on if the corresponding connections are properly made. Please see section 1.4 for detailed LED descriptions.

5